Store

Graphics

Machine Shop

BlockWork

HeadWork

PistonWork

Rod Work

CrankWork

Balancing

Assembly

Misc

CNC

DynoService

DynoJet 

HOME

Gallery

About Us

Block Work 

BORE BLOCK .030                               80.00 INSTALL LIFTER BUSHINGS        550.00
BORE ADDITIONAL .030                     40.00 JET SPRAY BLOCK                         75.00
HONE                                                    175.00  SOLVENT WASH BLOCK                50.00
HONE W/PLATE                                  220.00 REMOVE PLUGS                             65.00/HR
DECK BLOCK (YOU CHECK)              80.00 CLEARANCE FOR RODS               65.00/HR
DECK BLOCK (WE CHECK)               120.00 RESTRICT OIL                                   25.00
SQUARE W/ BHJ FIXTURE          ADD  40.00 INSTALL OIL SCREENS                   35.00
O-RING BLOCK                                    175.00 INSTALL CAM BEARINGS               40.00
CUT TOP OF BLOCK                             65.00 FREEZE PLUGS INSTALLED             60.00

                                               

         Square decking a Dart 351w ford block on our Peterson STC 361 CBN surface mill.  All blocks are set up on our BHJ fixture. 

                           This assures that all milling is done on plane with the crankshaft centerline

                          

                  Preparing a Dart small block for hone finishing cylinder walls on our Sunnen CV616

                                            We have a huge selection of deck torque plates

All honing is done in precise incremental steps, each with different grit stones or diamonds to give a precision plateau finish.

Hit Counter                  

Send mail to jdeleon@deleonauto.com with questions or comments about this web site.
Last modified: November 01, 2009